a small front garden fence.

we're slowly working on upping the curb appeal of the house. well, except for the yard, which we've stopped watering the lawn because of the drought so that's dying a slow, ugly death. anyway, there are utilities in the front of the house, that then run along side it. the pipes are painted the same color of the house, and there's a small garden bed in front of it, but they're still pretty visible.

in addition to that, at some point there were wired lights put into the garden, but they have never worked since we first bought the house, and they were even starting to fall apart. we finally decided to do something about it!

first we dug up those busted lights. at some point, the pipe just ends and becomes buried wire. that's not dangerous or anything... luckily, they were literally not connected to anything, and we were able to just pull them up!

one of the lights actually ran under the gas and water mains, and since we felt uncomfortable trying to dig it around those things, james just ended up sawing that one off several inches into the ground.

we cleaned up everything toward the back of the garden, moved a few plants, and started working on putting in a small redwood fence to match the fence and gate that went in a few months ago. we used some string to mark where we wanted the top front of the fence to go and then dug three one-foot-deep holes for posts.

we used pressure treated two-by-fours and quickrete fast-setting concrete mix for the posts. after letting it set overnight, we filled the remainder of the holes with some drainage rock, and used a circular saw to cut off the excess post.

we bought eight foot long six-by-one redwood for the fence itself, which matched most closely with the big fence. for this project, we bought some new toys from harbor freight! a three gallon air compressor and 18-gauge brad air nailer, both central pneumatic. we were going to just use a drill and screws, but this matched the way the fence was done and was so much faster, and easier, and totally worth the purchase.

the circular saw came back out to clean up the edges and then we stained it with the same penofin clear redwood stain that was used on the fence (pluse, we still had plenty leftover). some of the plants actually touch our new mini fence, so we had to get creative during the staining process..

after the stain was dried and the fence was finished (yay!) we added landscape barrier, stepping stones and pea gravel just to clean up the space and make it really look like a nice access area for the utilities.

we are pretty proud of ourselves! this is our first real DIY construction project! we've been slowly building up the tools we need over various small projects, and it really felt like we finally had the right tools to get this done without spending ridiculous amounts of money. getting this and the rocks into the side yard has made us really excited to get back to doing house projects again. i'm really hoping we get through a lot of fun outdoor projects this summer, and i can't wait to share them all!

the slow exterior beautification continues.

we needed to remove the two trees on the side of the house, as seen above. the one further down, that is in its own little circle, was pretty diseased. the one closest to camera was doing just fine, but right next to the house and foundation, which made us rather uncomfortable. we were sad to remove the trees, especially since our back and side yard is basically all concrete otherwise, but we really felt like we had to.

with the trees gone, the side looked sad with its little dirt patches, so we decided to do a little bit of cleanup.

we started by just tackling the patch right up against the house. knocked out those brick liners, raked the dirt clean of roots and other big pieces of debris, and used a cement block to tamp it flat.

then we put down landscape barrier and covered the whole thing in red desert rock.

tada! much cleaner right?

we have big plans to deck over much of the concrete you see, plus put in some raised garden beds over the red rock. it's been awhile since we've really done any hands-on house projects of our own, and this really got our juices going! we've already finished up another project that i haven't gotten around to blogging yet, but look for that soon!

a leaky situation.

california is in a major drought right now, and since we moved into the house in march 2013, we can count on one hand the number of times it has rained. the last time it rained however, we noticed that the window in the living room between the chimney and the television had a leak. there is a huge overhang typical of craftsman homes over the window, so we knew it wasn't the window itself that was leaky. the water was coming in somewhere higher up, and into and through the wall. you can see the drippage below if you look closely:

we suspected the chimney right away. when we had a chimney inspection done during escrow, we were told that the chimney was cracked at the roofline. james has also been on the roof before and seen how shoddy the flashing and shingles are done right around the chimney. we did our best to direct the leaking, especially since there is an outlet and the router right under the window. since the water was coming in the seams of the window, we couldn't even just put down a bucket, but used plastic bags and packaging tape to get it up off the walls and drip into our chosen receptacles.. 

in anticipation of the rain we are supposed to get this week, james went up on the roof and rubber-spray-patched all around the chimney on saturday. yup, we totally bought a $13 can of (as seen on tv!) flex seal from target. i didn't go on the roof myself, so i don't have any pictures of his handiwork, unfortunately. 

it rained gently on and off all sunday, and everything seemed okay. then it rained most of today, and pretty hard for some of it. when we first got home from work, we were really excited because we didn't see any moisture on the window. however, after closer inspection, we realized it was still leaking, though far less seriously than before. enough that we have to keep our ugly water-catching-solution around for awhile longer. we'll have to wait until the rain stops and we have a dry spell to try and do more sealing. then wait for it to rain again to see if it worked! the bad news, obviously, is that there is still water in our walls. the good news is that we're clearly targeting the right places! (and really, it doesn't rain enough here for this to be a serious problem...)